Alto-Shaam 1000-BQ2/192 Guide de dépannage télécharger pdf (Page 9)

THERMOSTAT ACCURACY

The electronic thermostat is a precise instrument and

is designed to offer trouble free service. If you

suspect the temperature inside the holding

compartment does not match the temperature

indicated on the digital display, follow the

instructions listed below.

1. Check to make certain the unit voltage matches

the power source. A power source less than that

required to operate the unit will result in

inaccurate temperatures.

2. Verify the temperature inside the holding

compartment with a qualify thermal indicator.

A. With the exception of the wire shelves,

completely empty the holding compartment.

B. Make certain the holding cabinet sensor,

located inside the holding compartment at

the left side of the unit, is completely clean.

C. Suspend the thermal indicator in the center

of the holding compartment.

D. Allow the temperature set on the electronic

thermostat to stabilize for a minimum of one

hour before comparing the digital display

with the reading on the thermal indicator.

DO NOT OPEN THE CABINET DOOR(S)

DURING THE TEMPERATURE

STABILIZATION PERIOD.

If the reading on the thermal indicator does not

match the digital display, there may be a problem

with the air sensor. See troubleshooting guide on

page 7 of this manual; or call the factory service

department for advice.

#846-8 INSTALLATION/OPERATION/SERVICE MANUAL • 8.

SERVICE SECTION

DISCONNECT UNIT FROM

POWER SOURCE BEFORE

CLEANING OR SERVICING.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

Pas de commentaire

Alto-Shaam 1000-BQ2/192 Guide de dépannage Page 9