Alto-Shaam QC-50 Instructions d'exploitation télécharger pdf (Page 17)

ELECTRONIC CONTROL ACCURACY

The electronic control is a precise instrument and is

designed to offer trouble-free service. If you suspect

the temperature inside the warming cabinet does not

match the temperature indicated on the digital

display, after stabilizing, follow the instructions

listed below.

1. Check to make certain the unit voltage matches

the power source. A power source less than that

required to operate the unit will result in

inaccurate temperatures.

2. Verify the temperature inside the holding

compartment with a qualify thermal indicator.

A. With the exception of the wire shelves,

completely empty the holding compartment.

B. Make certain the holding cabinet sensor,

located inside the holding compartment at

the left side of the unit, is completely clean.

C. Suspend the thermal indicator in the center

of the holding compartment.

D. Allow the temperature set on the electronic

thermostat to stabilize for a minimum of one

hour before comparing the digital display

with the reading on the thermal indicator.

DO NOT OPEN THE CABINET DOOR(S)

DURING THE TEMPERATURE

STABILIZATION PERIOD.

If the reading on the thermal indicator does not

match the digital display, there may be a problem

with the air sensor. See troubleshooting guide in this

manual, or call the factory service department for

advice.

#891/3 • INSTALLATION/OPERATION/SERVICE MANUAL • 16.

SERVICE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Alto-Shaam QC-50 Instructions d'exploitation Page 17